Lantronix EDS1100 Guía de usuario descargar pdf (Pagina 55)

8: Line and Tunnel Settings

EDS1100/2100 User Guide 54

3. Click Submit.

Connect Mode

Connect Mode defines how the EDS1100/2100 makes an outgoing connection. For Connect Mode

to function, it must be enabled, have a remote station configured, and a remote port configured

(TCP or UDP). When enabled, Connect Mode is always on.

Enter the remote station as an IP address or DNS name. The EDS will not make a connection

unless it can resolve the address. For DNS names, after 4 hours of an active connection, the EDS

will re-evaluate the address. If it is a different address, it will close the connection.

Connect Mode supports the following protocols:

 TCP

 AES encryption over TCP and UDP

 SSH (the EDS1100/2100 is the SSH client)

 SSL

Local Port Enter the port number for use as the local port. The defaults are port 10001

for Tunnel 1 and port 10002 for Tunnel 2.

Protocol Select the protocol type for use with Accept Mode. The default protocol is

TCP. If you select TCP AES you will need to configure the AES keys.

TCP Keep Alive Enter the time, in seconds, the EDS1100/2100 waits during a silent

connection before checking if the currently connected network device is still

on the network. If the unit then gets no response after 8 attempts, it drops that

connection.

Flush Serial Data Select Enabled to flush the serial data buffer on a new connection.

Block Serial Data Select On to block, or not tunnel, serial data transmitted to the EDS1100/

2100.

Block Network Data Select On to block, or not tunnel, network data transmitted to the EDS1100/

2100.

Password Enter a password that clients must send to the EDS1100/2100 within 30

seconds from opening a network connection to enable data transmission.

The password can have up to 31 characters and must contain only

alphanumeric characters and punctuation. When set, the password sent to

the EDS1100/2100 must be terminated with one of the following: (a) 0x0A

(LF), (b) 0x00, (c) 0x0D 0x0A (CR LF), or (d) 0x0D 0x00.

Email on Connect Select whether the EDS1100/2100 sends an email when a connection is

made. Select None if you do not want to send an email. Otherwise, select the

Email profile to use for sending.

Email on Disconnect Select whether the EDS1100/2100 sends an email when a connection is

closed. Select None if you do not want to send an email. Otherwise, select

the Email profile to use for sending.

CP Output Identifies a CP or CP Group whose value should change when a connection

is established and dropped.

Table 8-15 Tunnel Accept Mode Fields (continued)

Field Description

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 156 157

Comentarios a estos manuales

Sin comentarios

Lantronix EDS1100 Guía de usuario Pagina 55

Comentarios a estos manuales

Relacionado con productos y manuales para Servidores De Serie Lantronix EDS1100