Lantronix EDS1100 Guía de usuario Pagina 28

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 157
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 27
4: Installation of EDS2100
EDS1100/2100 User Guide 27
The Ethernet port has two LEDs that indicate the status of the connection as follows:
Left LED
- Green ON 100Mbps Link
- Green Blink 100Mbps Activity
- Orange ON 10Mbps Link
- Orange Blink 10Mbps Activity.
Right LED
- Green ON Full Duplex.
- OFF Half Duplex
The Ethernet port can connect to an Ethernet (10 Mbps) or Fast Ethernet (100 Mbps) network.
Reset Button
You can reset the EDS2100 to factory defaults, including clearing the network settings. The IP
address, gateway, and netmask are set to 00s. To reset the unit to factory defaults, perform the
following steps.
1. Place the end of a paper clip or similar object into the reset opening and press for a minimum
of 3 seconds.
2. Remove the paper clip to release the button. The firmware restores factory default settings to
the configuration and reboots the unit.
Top LEDs
Figure 4-6 shows the top of the EDS2100. Table 4-1 lists and describes the LEDs.
Figure 4-6 EDS2100 Top LEDs
Table 4-1 EDS2100 LEDs and Descriptions
LED Description
Power (blue) ON—EDS is receiving power
TX Serial 1 (green) Blinking—EDS is transmitting data on serial port 1
RX Serial 1 (yellow) Blinking—EDS is receiving data on serial port 1
Vista de pagina 27
1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 156 157

Comentarios a estos manuales

Sin comentarios