
8: Line and Tunnel Settings
EDS1100/2100 User Guide 47
Tunnel Statistics
The EDS1100/2100 logs tunneling statistics. The Dropped statistic shows connections ended by
the remote location. The Disconnects statistic shows connections ended by the EDS1100/2100.
To display the tunnel statistics, perform the following steps.
1. Click Tunnel on the Main Menu. Figure 8-6 shows the page that displays.
Figure 8-6 Tunnel 1 Statistics Web Page
Serial Settings
Serial line settings are configurable for both serial line 1 and serial line 2. Configure the buffer size
to change the maximum amount of data the serial port stores. For any active connection, the
EDS1100/2100 sends the data in the buffer.
The modem control signal DTR on the Line may be continually asserted or asserted only while
either an Accept Mode tunnel or a Connect Mode tunnel is connected.
To configure the serial settings, perform the following steps.
1. Click Tunnel > Tunnel 1 > Serial Settings. Figure 8-7 shows the page that displays.
Comentarios a estos manuales