
8: Line and Tunnel Settings
EDS1100/2100 User Guide 52
Accept Mode supports the following protocols:
SSH (EDS1100/2100 acts as the server). When using SSH, the SSH server host keys and at
least one SSH authorized user must be configured.
SSL
TCP
AES encryption over TCP
Telnet (EDS1100/2100 supports IAC codes. It drops the IAC codes when Telnetting and does
not forward them to the serial port).
Accept Mode has the following states:
Disabled (never a connection)
Enabled (always listening for a connection)
Active if it receives any character from the serial port
Active if it receives a specific (configurable) character from the serial port (same start
character as Connect Mode’s start character)
Modem control signal
Modem emulation
To configure Accept Mode, perform the following steps.
1. Click Tunnel 1 > Accept Mode. Figure 8-14 shows the page displays.
Comentarios a estos manuales