
SCSxx05/SCSxx20 User Guide 4: Configuration
4-7
4. Backspace over the existing data, and enter your name for this port. The
device name cannot contain a space. Use an underscore if you need an
empty space in the name.
5. Press Enter. You have two options:
To go back and name or rename the same device port, repeat steps 3-5.
To save your name change to flash memory now, select Done and
press Enter: A confirmation screen displays. Continue with step 6.
6. To confirm, select Yes. You cannot undo these name changes after this
point. (If you select No, you return to the previous screens to make changes.)
7. Press Enter. There is a short delay while the system saves the changes to
flash memory. Now you can name a different port of group of ports.
8. You have two options:
To repeat the process of naming ports for a different port or group of
ports, select Yes.
To move on to the next option, Device Port Parameters, select No.
9. Press Enter. If you selected No, the Configure Device Port menu returns
with Device Port Parameters selected.
Device Port Parameters
You can configure the device port parameters on individual ports or in ad hoc
groups. You determine the group and then apply selected features to the ports in
that group.
The device port parameters that you configure include:
Enable/disable operator mode (default is disabled)
Baud rate (default is 9600)
Data bits (default is 8)
Stop bits (default is 1)
Parity (default is None)
Flow control (default is XON/XOFF)
Port type (default is DTE for the SCSxx05 and DCE for the SCSxx20))
Inhibit buffering (default is no)
Define a Group of Ports to Configure
1. Select Device Port Parameters and press Enter.
2. Select Setup the Device Parameters and press Enter. You are prompted to
identify the port or ports that should be configured with these steps.
Comentarios a estos manuales