Lantronix EDS8PS Guía de usuario Pagina 51

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 163
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 50
8: Network Settings
EDS User Guide 51
Note: If DHCP or BOOTP fails, AutoIP intervenes and assigns an address. In this
case, the static IP (if configured) is ignored.
Network 1 Ethernet Link
This page shows the current negotiated Ethernet settings and lets you change the
speed and duplex settings.
View and configure the Ethernet link:
1. Click Network on the menu bar.
2. Then click Network 1 and Link at the top of the page, as shown below.
The Network 1 (eth0) Ethernet Link page appears.
Figure 8-3. Network 1 Ethernet Link
Status shows the current negotiated settings.
Configuration shows the current range of allowed settings.
3. Enter or modify the following settings:
Network 1-Ethernet
Link Page Settings
Description
Ethernet Link Speed Select the Ethernet link speed. (Default is Auto.)
Ethernet Link Duplex Select duplex mode. (Default is Auto.)
4. Click Submit. The changes take effect immediately.
Vista de pagina 50
1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 162 163

Comentarios a estos manuales

Sin comentarios