Lantronix WiSpan Manual de usuario descargar pdf (Pagina 13)

WiSpan User Guide 13

This chapter describes how to install and configure the WiSpan unit to get it up and

running. You must configure the WLAN settings for the WiSpan to communicate on a

wireless network.

Note: You only need to configure the WiSpan's IP address and other network settings if

you want to discover and configure your WiSpan device from the wired network; these

settings only apply to communication on the Ethernet interface.

Installing the WiSpan for Configuration

There are two methods for installing the WiSpan so that you can configure it:

Using the Setup Port

To connect to and initially configure the WiSpan using the setup port:

1. Connect one end of the supplied DB9F – DB9F null modem serial cable to the

WiSpan’s setup port.

2. Connect the other end of the DB9 serial cable to a terminal or a PC’s serial COM

port.

3. Continue with Using Setup Mode for Server and WLAN Configuration, below.

Figure 4-1. WiSpan Connected for Configuration via the Serial Port

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 47 48

Sin comentarios

Lantronix WiSpan Manual de usuario Pagina 13