Lantronix XPort Manual de usuario descargar pdf (Pagina 57)

Monitor Mode is a command-line interface used for diagnostic purposes.

This chapter includes the following topics:

Topic Page

Entering Monitor Mode via the Serial Port 7-1

Entering Monitor Mode via the Network Port 7-1

Monitor Mode Commands 7-2

There are two ways to enter Monitor Mode: locally via the serial port or remotely via

the network.

Entering Monitor Mode via the Serial Port

To enter Monitor Mode locally:

1. Follow the same steps used for setting the serial configuration parameters (see

Using the Serial Port on page 4-2).

2. Instead of typing three x keys, however:

a) Type zzz (or xx1) to enter Monitor Mode with network connections.

b) Type yyy (or yyy) to enter Monitor Mode without network connections.

A 0> prompt indicates that you have successfully entered Monitor Mode.

Entering Monitor Mode via the Network Port

To enter Monitor Mode using a Telnet connection:

1. Establish a Telnet session to the configuration port (9999). The following

message appears:

MAC address 00204A0113A3

Software version 01.0b9 (021219) XPT

Press Enter to go into Setup Mode

2. Type M (upper case).

A 0> prompt indicates that you have successfully entered Monitor Mode.

XPort™ User Guide 7-1

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 86 87

Sin comentarios

Lantronix XPort Manual de usuario Pagina 57