Lantronix TS-DDH Manual de usuario

TS-DDH TigerStop® Manual Data Downloading May 2006

Data Downloading Hardware 8 Fig. 4 4. Select "Assign a specific IP address" (Fig. 4) and click Next. The IP Settings screen displays. In F

Run Ethernet Device Installer 9 Fig. 6 6. Click Assign. The new address will be saved, and the Ethernet adaptor will be rebooted (Fig. 7). Fig. 7 7

Data Downloading Hardware 10 Fig. 8 The DeviceInstaller 3.6 window (Fig. 9) will appear. Fig. 9 2. This time, click Configure. The Configure Device

Run Ethernet Device Installer 11 The Advanced tab (Figs. 12-13) displays all the port properties in detail. Fig. 12 Fig. 13 5. In the 1. Serial Set

Data Downloading Hardware 12 Fig. 14 7. Click Apply. The program should now update the settings and reboot the device. When in use, both ports shoul

13 The Ethernet Redirector Install the Redirector from the CD. 1. Choose the destination folder (Fig. 1) for the Redirector. Fig. 1 2. Click Next.

Data Downloading Hardware 14 Fig. 3 4. Click Finish to complete the install. Launch the Redirector. Fig. 4 1. Open the Com Port Redirector and set

The Ethernet Redirector 15 8. Click OK. 9. Click Save. 10. Select COM4 from the top-center “Redirect To” drop down menu. 11. Click the Add IP button

16 ESC Troubleshooting Follow these steps in case of a communications failure: 1. Confirm hardware connections 2. Confirm software settings 3. Con

17 SX Serial Extender Description and Use The Serial Extender allows your computer to communicate with your Level 2 (or higher) TigerStop when the to

ii Table Of Contents Ethernet to Serial Converter...

Data Downloading Hardware 18 4. Plug the 5v power supply (Fig. 6) into RS232 Sender. 5. Restart your computer only after making all the connections.

1 ESC Ethernet to Serial Converter Description and Use The ESC is an Ethernet-RS232 adapter that lets you plug TigerStop into an ethernet network, el

Data Downloading Hardware 2 2. Enter the factory password and press . 3. The Service Menu will display the first six options. Version 3.1 di

Ethernet to Serial Converter 3 Continue by turning to the following topics: 1. Install the Ethernet Device Installer 2. Run the Ethernet Device Inst

4 Ethernet Device Installer Fig. 1 To use the ESC Ethernet-to-Serial Converter, some software on the accompanying CD (CD-UDS-04A) must first be inst

Ethernet Device Installer 5 Fig. 4 4. Continue at the DeviceInstaller Setup Wizard. The DeviceInstaller Setup Wizard (Fig. 5) will appear. Fig. 5 5

Data Downloading Hardware 6 Fig. 7 7. Click Close. Run Ethernet Device Installer

7 Run Ethernet Device Installer Assign the IP Address and Network Class. 1. Click the START button on the task bar and select All Programs > Lant